This is a simple method that simply
involves ripping out the seam on each side to allow for the digonal of
the roll bar. There is no cutting and no sewing involved.
|
It is really very simple. A seam ripper works
perfectly. If you don't have one handy, then a razor blade, X-acto knife or a
very sharp knife will work but you'll have to be very careful. Do not go all the
way. As you can see by the "Stop Point" you must leave some of
the seam intact.
|
 |
|
From the underneath - you open each corner
seam like this.. |
 |
When you are done, there is enough of an edge remaining
that you could attach Velcro if your wanted.
|
When it is finished - it should look like this.
|
 |
|
|
Disclaimer - We offer this as a possible solution
to modifying your boot. We are not responsible for you cutting too much,
too little or in general screwing up your boot. We did it to ours and
several other boots and it works great. If your are not sure about doing
it yourself. Use method #1 above.
|
