Key Features
- No boot cover alterations required.
- Allows full seat travel and tilt (main hoop diagonal
limits passenger seat)
- Available with powder coat finish or polished
stainless steel
- 3/16" Mounting and back-up plates
- Does not interfere with convertible top operation.
- Includes rear brace crossbar for shoulder harness
mounting.
- Fits full height and width of the interior.
- Constructed of high quality 1020 DOM tubing (1
3/4" diameter by .125 wall )
- Complete installation instruction sheet included
along with all other hardware needed.
Complete Installation Instructions
|
Installation Information
- Must drill holes in several places.
- Must cut panels and plastic
- Tools Needed:
16mm (or 5/8 socket) wrench
5/16 Allen wrench
10 mm wrench or deep socket
2 - 9/16 wrenches
1.75" hole saw
Drill with 3/8 drill bit
2 #2 Phillips screwdriver
- 1 long & 1 short
Half round file
Aviation snips for cutting panels
Phillips head screwdriver
T-40 Torx Drive 6 pt.
Drill & long 3/8" drill bit
Jack and Jack Stands
Heat gun for fitting plastic
interior panels
C-Clamp for clamping back-up
plates while drilling
Safety glasses
- Sorry but the power top cylinder will have to go to make room for
the bar.
|
